基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

Optimisation of the ultrasound-assisted extraction of betalains and polyphenols from Amaranthus hypochondriacus var. Nutrisol

The present study optimised the ultrasound-assisted extraction (UAE) of bioactive compounds from Amaranthus hypochondriacus var. Nutrisol. Influence of temperature (25.86–54.14 °C) and ultrasonic power densities (UPD) (76.01–273.99 mW/mL) on total betalains (BT), betacyanins (BC), betaxanthins (BX), total polyphenols (TP), antioxidant activity (AA), colour parameters (L*, a*, and b*), amaranthine (A), and isoamaranthine (IA) were evaluated using response surface methodology. Moreover, betalain extraction kinetics and mass transfer coefficients (K_La) were determined for each experimental condition. BT, BC, BX, TP, AA, b*, K_La, and A were significantly affected (p < 0.05) by temperature extraction and UPD, whereas L*, a*, and IA were only affected (p < 0.05) by temperature. All response models were significantly validated with regression coefficients (R²) ranging from 87.46 to 99.29%. BT, A, IA, and K_La in UAE were 1.38, 1.65, 1.50, and 29.93 times higher than determined using conventional extraction, respectively. Optimal UAE conditions were obtained at 41.80 °C and 188.84 mW/mL using the desired function methodology. Under these conditions, the experimental values for BC, BX, BT, TP, AA, L*, a*, b*, K_La, A, and IA were closely related to the predicted values, indicating the suitability of the developed quadratic models. This study proposes a simple and efficient UAE method to obtain betalains and polyphenols with high antioxidant activity, which can be used in several applications within the food industry.     

Cu/CuO-Graphene Foam with Laccase-like Activity for Identification of Phenolic Compounds and Detection of Epinephrine

Although great progress has been made in the advancement of nanozymes, most of the studies focus on mimicking peroxidase, oxidase, and catalase, while relatively few studies are used to mimic laccase. However, the use of nanomaterials to mimic laccase activity will have great potential in environmental and industrial catalysis. Herein, Cu/CuO-graphene foam with laccase-like activity was designed for the identification of phenolic compounds and the detection of epinephrine. In a typical experiment, the formation mechanism of Cu/CuO-graphene foam was investigated during the pyrolysis process by thermogravimetric-mass spectrometry. As a laccase mimic, Cu/CuO-graphene foam exhibited excellent catalytic activity with a Michaelis-Menten constant and a maximum initial velocity of 0.17 mmol/L and 0.012 mmol∙L^-1∙s^-1, respectively. Based on this principle, Cu/CuO-graphene foam nanozyme could differentially catalyze phenolic compounds and 4-aminoantipyrine for simultaneous identification of phenolic compounds. Furthermore, a colorimetric sensing platform was fabricated for the quantitative determination of epinephrine, showing linear responses to epinephrine in the range of 3 mg/mL to 20 mg/mL with the detection limit of 0.2 mg/mL. The proposed Cu/CuO-graphene foam nanozyme could be applied for the identification of phenolic compounds and the detection of epinephrine, showing great potential applications for environmental monitoring, biomedical sensing, and food detection fields.     

A Dual Threat: Redox-Activity and Electronic Structures of Well-Defined Donor–Acceptor Fulleretic Covalent-Organic Materials

The effect of donor (D)–acceptor (A) alignment on the materials electronic structure was probed for the first time using novel purely organic porous crystalline materials with covalently bound two- and three-dimensional acceptors. The first studies towards estimation of charge transfer rates as a function of acceptor stacking are in line with the experimentally observed drastic, eight-fold conductivity enhancement. The first evaluation of redox behavior of buckyball- or tetracyanoquinodimethane-integrated crystalline was conducted. In parallel with tailoring the D-A alignment responsible for “static” changes in materials properties, an external stimulus was applied for “dynamic” control of the electronic profiles. Overall, the presented D–A strategic design, with stimuli-controlled electronic behavior, redox activity, and modularity could be used as a blueprint for the development of electroactive and conductive multidimensional and multifunctional crystalline porous materials.     

三维非连续变形分析方法碰撞分析及其应用

将具有完备动力学理论的非连续变形分析(DDA)方法应用于块体碰撞研究。基于三维DDA(3D DDA)方法,按时步输出块体碰撞过程速度变化和接触嵌入量,进而得到块体碰撞恢复系数、冲量、冲击力。以此为参考指标,采用斜抛、面-面对心等碰撞模型,验证3D DDA方法模拟块体碰撞的有效性,并将3D DDA方法应用于多米诺骨牌倾倒、滚石边坡成灾及防护等算例分析,探讨了多米诺骨牌倾倒机制、滚石启动及运动行为、滚石灾害防护方案。结果表明:多米诺骨牌间距越大,同一块体被碰撞时间越迟,其最终稳定时间也越迟,与下一块体碰撞的动能越大;滚石运动呈侧向平动及转动三维运动特征,每一次碰撞,均引起动能、轨迹或状态的显著变化;滚石拦挡设施弹簧刚度越大,越先达到最大冲击力,最大冲击力随弹簧刚度的增加而减小;可结合树木阻挡效应,耗散滚石动能,降低滚石飞跃高度,使滚石灾害减轻或控制在防护范围以内。     

Van't Hoff analysis in chiral chromatography

The present review discusses the theory and application of van't Hoff analysis in chiral chromatography, with main focus on liquid chromatography. The topics considered include the physical meaning of van't Hoff equation's parameters, interpretation of thermodynamic data in terms of retention and enantioseparation mechanisms, abnormal behavior of van't Hoff plots, and best practices to avoid biased results.     

A Comparison of Two Isoreticular Metal–Organic Frameworks with Cationic and Neutral Skeletons: Stability,Mechanism, and Catalytic Activity

Although many ionic metal–organic frameworks (MOFs) have been reported, little is known about how the charge of the skeleton affects the properties of the MOF materials. Herein we report how the chemical stability of MOFs can be substantially improved through embedding electrostatic interactions in structure. A MOF with a cationic skeleton is impervious to extremely acidic, oxidative, reductive, and high ionic strength conditions, such as 12 m HCl (301 days), aqua regia (86 days), H₂O₂ (30 days), and seawater (30 days), which is unprecedented for MOFs. DFT calculations suggested that steric hinderance and the repulsive interaction of the cationic framework toward positively charged species in microenvironments protects the vulnerable bonds in the structure. Diverse functionalities can be bestowed by substituting the counterions of the charged framework with identically charged functional species, which broadens the horizon in the design of MOFs adaptable to a demanding environment with specific functionalities.     

Synthesis of Axially Chiral Styrenes through Pd-Catalyzed Asymmetric C−H Olefination Enabled by an Amino Amide Transient Directing Group

The atroposelective synthesis of axially chiral styrenes remains a formidable challenge due to their relatively lower rotational barriers compared to the biaryl atropoisomers. Herein, we describe the construction of axially chiral styrenes through Pd^II-catalyzed atroposelective C−H olefination, using a bulky amino amide as a transient chiral auxiliary. Various axially chiral styrenes were produced with good yields and high enantioselectivity (up to 95 % yield and 99 % ee). Carboxylic acid derivatives of the resulting axially chiral styrenes showed superior enantiocontrol over the biaryl counterparts in Co^III-catalyzed enantioselective C(sp³)−H amidation of thioamide. Mechanistic studies suggest that C−H cleavage is the enantioselectivity-determining step.     

Electrical and Thermal Transport Properties of n-type Bi6Cu2Se4O6 (2BiCuSeO + 2Bi2O2Se)

New thermoelectric materials, n-type Bi₆Cu₂Se₄O₆ oxyselenides, composed of well-known BiCuSeO and Bi₂O₂Se oxyselenides, are synthesized with a simple solid-state reaction. Electrical transport properties, microstructures, and elastic properties are investigated with an emphasis on thermal transport properties. Similar to Bi₂O₂Se, it is found that the halogen-doped Bi₆Cu₂Se₄O₆ possesses n-type conducting transports, which can be improved via Br/Cl doping. Compared with BiCuSeO and Bi₂O₂Se, an extremely low thermal conductivity can be observed in Bi₆Cu₂Se₄O₆. To reveal the origin of low thermal conductivity, elastic properties, sound velocity, Grüneisen parameter, and Debye temperature are evaluated. Importantly, the calculated phonon mean free path of Bi₆Cu₂Se₄O₆ is comparable to the interlayer distance for BiO─CuSe and BiO─Se layers, which is ascribed to the strong interlayer phonon scattering. Contributing from the outstanding low thermal conductivity and improved electrical transport properties, the maximum ZT ≈0.15 at 823 K and ≈0.11 at 873K are realized in n-type Bi₆Cu₂Se_3.2Br_0.8O₆ and Bi₆Cu₂Se_3.6Cl_0.4O₆, respectively, indicating the promising thermoelectric performance in n-type Bi₆Cu₂Se₄O₆ oxyselenides.